![]() ![]() If the Seagate external hard drive does not show up after these manipulations, the last option to check is to try connecting it directly via the computer’s SATA interface. Connecting the disk directly to SATA interface It makes no sense to look further for a reason for its “invisibility” in Windows or other systems because there is a hardware problem (with cables or cords, with the disk itself, with USB ports). If you connected the disk to several computers - it does not show any signs of life (the led does not light, the sound of movement inside is inaudible). When you try an additional computer, make sure to examine whether it shows up in the personal computer’s Disk Management window, not only in This PC. If the drive doesn’t work on any kind of machine you plugged it into, the external HDD itself is most likely dead, and you’ll need to change it. If you have an additional computer nearby, attempt plugging the hard disk into it to check whether it’s detected. If it shows up in one USB port but not another, you might have a dead USB port. Unplug the drive from its current USB port and try plugging it right into one more port on your computer. When you connect an external drive, Windows makes a distinctive sound.įailure of an individual USB port or the entire USB hub.In rare cases, there may be a hum, but this is an apparent reason to disable the equipment since its mechanical part is damaged and needs to be urgently examined by the service center. Listen carefully to all extraneous sounds, including clicks, crackles, and rustles. These sounds happen when power is connected. When you turn on the HDD, the mechanical part begins to emit a barely audible sound of the motor (spindle), which rotates a disk platter and starts a disk read/write head. Detect sounds during operation (this applies to HDD).If there is no critical data on it, you can try opening an enclosure and connecting the HDD directly to the PC, as will be discussed below. If the LED is not lit (and the drive is not recognized) – there may be a problem not with the disk itself, but with a controller. If the LED is not lit, there may be a problem with the USB cord or USB port (we recommend trying to connect it to another USB port or another device: a computer or laptop). Almost all external drives are equipped with LEDs that start to light or blink when connected to USB. How to determine whether the Seagate drive you are trying to access is damaged or defectiveįollowing external signs help you to understand why the Seagate external hard drive is not working: The disk is dead – return it under warranty if possibleįormat the disk to a suitable file system The Seagate drive is damaged or defective ![]() Enabled Fast Start-up option in Windowsįor a better understanding of why your computer is not recognizing hard drive, the table below lists the problems and their solutions briefly: Possible cause.A Seagate drive that you are trying to access is damaged or defective.Let’s look at them in the following order: In any case, we need to understand the cause of the problem and ensure the hard drive works properly.Ī Seagate external hard drive is not recognized due to a few technical reasons. This situation can affect almost any Seagate drive lineup: So, your computer is faced with a problem when a Seagate external hard drive is not showing up. Disable fast startup to resolve Seagate external hard drive not showing up.The drivers installed on the computer are outdated or incompatible.Connecting the disk directly to SATA interface. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |